|
Choosing the
Accessories |
|
INTRODUCTION |
When deciding on the type of hose, filtration and connections
the location of the compressor, safety, quality of air and speed of
connecting equipment need to be taken into consideration. |
|
HOSES |
There are different types of hoses available for compressed
air.
Always
make sure that the hose has a rating which is equal or higher than the
maximum pressure of the compressor, standard compressed air hoses are
usually rated at 10 Bar.
never use hoses not rated for compressed air.
A simple 10m coil hose or flexible rubber hose would be ideal
for use with a small direct drive compressor when operating a spray gun for
fence panels, decking etc. Longer hoses would be required when undertaking
spray tasks using a larger compressor as the compressor cannot always be
located close to the spray area. |
|
Coiled Rilsan Hose |
Rubber Hose |
|
REGULATORS |
A regulator is fitted as
standard on a portable compressors and available as an optional on larger
units. This will enable the pressure of the compressed air to be adjusted
in line with recommended pressure of the particular spray gun or air tool
being used.
|
|
Regulator with filter |
Regulator |
|
FILTERS, WATER TRAPS |
Extra filtration to remove oil and water can be added to the
system when better quality of air is required such as car panel spraying or
professional finishes. When purchasing a small oil free unit the oil
content is nil and the standard regulator is suitable for spraying most
domestic materials such as fence guard, emulsions, deck seals, etc. |
|
|
|
|
CONNECTORS |
Quick connector couplings are a very useful addition to any
compressed air system as it allows for the speedy and safe changing of air
tools. It will stop the air escaping when the hose is disconnected.
For example, changing from an air blow gun (dusting of spray
surface) to the spray gun is achieved in seconds, safely. |
|
Quick release coupling |
Coupler, connector |
|
SAFETY
EQUIPMENT |
When spraying any material whether water or solvent based it
is important to wear a nose/mouth mask or respirator.
It is vital when purchasing these products to inform the vendor of the type
of material being sprayed as wearing the wrong masks is as useful as wearing
no mask at all.
Other equipment is optional such as overalls and shoes.
Protective goggles are advisable due to over spray especially for spectacles
wearers. In many cases the manufacture of the finishing material will
indicate the protective measures such as facemasks, gloves, goggles, etc.
However, if in any doubt the manufacture should be contacted.
|
 |
Protective Mask |
|
USE YOUR SPRAY GUN FOR: TIME SAVING – VERSATILITY – QUALITY FINISH – EASE OF
LEARNING - |
| |
|
