VT Rotary Air Compressor

ABAC ROTARY SCREW COMPRESSOR AIR END
The ABAC air end features the latest version asymmetric profile rotors which are of patented design. The new air end gives higher output per kW of power consumed. The rotors rotate at lower speeds with lower tip velocity and are mounted on over capacity bearings to achieve a longer operating life.

INSTALLATION
Each ABAC ‘VT’ compressor is supplied ready for immediate installation, complete with all accessories including lubricant. The careful design of the cabinet provides dual compressed air outlets and top mounted
air inlet/outlet vents so that the compressor can be positioned easily. The ‘VT’ compressor is extremely compact and requires the minimum of space.

ACCESSIBILITY
The ‘VT’ compressor is fitted with easily removable front, top and back panels. The careful positioning of the normal service components within one area of the cabinet provides ease of maintenance and therefore minimum downtime.

CLEAN INLET AIR
The cabinet on the ‘VT’ compressor is designed to offer protection from the ingress of dirt onto the components within the compressor and also to provide better quality inlet air for compression. This is achieved by a sealed cabinet that draws ambient air into the compressor through a top mounted panel filter. The air for compression then enters a high efficiency air inlet filter for further cleaning. This facility provides far fewer problems with blocking of coolers etc, and ultimately better quality compressed air.

LOW POWER CONSUMPTION
The ‘VT’ compressor is equipped with automatic dual control which allows the compressor to operate in either on load/off load mode or stop/start mode according to the air demand. This allows very economical operation during all types of load conditions.

CONTROL AND COMMAND PANEL
The very comprehensive standard controls offered on the ‘VT’ compressor provide fault diagnosis and safety warnings via the ‘check control’ panel and also service requirements are illustrated on the maintenance indicator.

STAR/DELTA STARTER
The starter within the ‘VT’ compressor is manufactured from high quality components in accordance with CEE standards. Low voltage control circuit, double insulated main and auxiliary circuit, phase relay (direction of rotation protection) and IP55 enclosure are all standard providing high levels of safety and reliability.

FOUR STAGE AIR/OIL SEPARATION
The ‘VT’ compressor benefits from a very efficient air/oil separation facility. Two stages of primary separation and
a further two stages of filtration result in very high quality compressed air with oil carry over of only 3 mg/m3. In addition low pressure losses are achieved resulting from a larger capacity reservoir and a greater filter cartridge surface area.

Model	Working Pressure		Capacity		Motor		Noise	Dims (mm)	Wgt
	\|Bar	Psi\|	\|m/min	cfm\|	\|kW	HP\|	\|db(A)\|	\|wxdxh\|	\|Kg\|

VT 4008	8	116	4.60	162.63	30	40	72	1450x800 x1300	500
VT 4010	10	145	4.00	141.41
VT 4013	13	188	3.40	120.20

VT 5008	8	116	6.15	217.42	37	50	73	1600x1100 x1450	700
VT 5010	10	145	5.20	183.84
VT 5013	13	188	4.40	155.56

VT 6008	8	116	7.30	258.08	45	60	74	1600x1100 x1450	750
VT 6010	10	145	6.30	222.73
VT 6013	13	188	5.40	190.91

VT 7008	8	116	8.50	300.14	55	75	74	160x1100 x1450	840
VT 7010	10	145	7.11	251.05
VT 7013	13	188	6.16	217.51